WORX WU370 18V 2.6 Ah Lithium Ion Cordless Hammer Drill - Manual (Page 9)

9
Operating instructions
note: Before using the tool, read the instruction book carefully.
intended uSe
The machine is intended for driving in and loosening screws as well
as for drilling in wood, metal, ceramic and plastic.
BefoRe Putting into oPeRation
a) cHaRging tHe BatteRy
The battery charger supplied is matched to the Li-ion battery installed
in the machine. Do not use another battery charger.
The Li-ion battery is protected against deep discharging. When
the battery is empty, the machine is switched off by means of a
protective circuit: The chuck no longer rotates.
In a warm environment or after heavy use, the battery pack may
become too hot to permit charging. Allow time for the battery to cool
down before recharging.
When the battery is charged for the first time and after prolonged
storage, the battery will only accept approximately 60% charge.
However, after several charge and discharge cycles the battery will
accept a 100% charge.
B) to ReMove oR inStall BatteRy Pack (See fig.a)
Press the battery pack latch and remove the battery pack from the
drill. After recharge slide the battery pack into drill’s battery port. A
simple push and slight pressure will be sufficient.
A
B