WORX WU127 12V 1.3 Ah Lithium Ion Cordless Drill/ Driver User Manual

Page 11

Gear i
Low speed range: for screwdriving or working with large drilling
diameter.
Gear ii
High speed range: for working with small drilling diameter.

warning: to prevent gear damage, always allow the

chuck to come to a complete stop before changing the
direction of rotation or the two-speed gear control.

cHUck aDJUStMeNt (See D)
To open the chuck jaws rotate the front section of the chuck. Insert
the drill bit between the chuck jaws and rotate the front section in
the opposite direction. Ensure the drill bit is in the center of the chuck
jaws. Finally, firmly rotate the front chuck section in the opposite
directions. Your drill bit is now clamped in the chuck.

toRQUe aDJUStMeNt (See e)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque adjustment ring. The
torque is greater when the torque adjustment ring is set on a higher
setting. The torque is less when the torque adjustment ring is set on
a lower setting.
Make the setting as follows:

1 - 4

for driving small screws

5 - 9

for driving screws into soft material

10 - 15 for driving screws into soft and hard material

for heavy drilling