WORX WU127 12V 1.3 Ah Lithium Ion Cordless Drill/ Driver - Manual (Page 10)

10
The on/off switch is fitted with a brake function which stops your
chuck immediately when you quickly release the switch.
It is also a variable speed switch that delivers higher speed and
torque with increased trigger pressure. Speed is controlled by the
amount of switch trigger depression.
warning: Do not operate for long periods at low speed
because excess heat will be produced internally.
SwitcH lock
The switch trigger can be locked in the OFF position. This helps
to reduce the possibility of accidental starting when not in use.
To lock the switch trigger, place the rotation control in the center
position.
ReveRSiBle (See B)
For drilling and screw driving use forward rotation marked “
”
(lever is moved to the left). Only use reverse rotation marked
“
” (lever is moved to the right) to remove screws or release a
jammed drill bit.
warning: Never change the direction of rotation when
the chuck is rotating, wait until it has stopped!
two-SPeeD GeaR coNtRol (See c)
The drill has a two-speed gear control designed for drilling or
driving at LO (mark is 1) or HI (mark is 2) speeds. A slide switch is
located on top of the drill to select either LO or HI speed. When
using the drill in the LO speed range, the speed will decrease and
the drill will have greater power and torque. When using the drill in
the HI speed range, the speed will increase and the drill will have
less power and torque.
2
3
4
A B
C D
E F