Specifications – Wood’s Powr-Grip FL4HV11AC User Manual
Page 5

Rev 15.0/1-14
3
FL4HV11AC: #35030
SPECIFICATIONS
Model Number:
FL4HV11AC
Description:
Designed for use with a crane or other hoisting equipment, the FL4HV11AC lifter
employs vacuum to hold a load for lifting in the flat orientation.
Power Source:
See serial number plate for specific AC voltage, frequency and amperage.
Vacuum Pads:
1
Four 10" [25 cm] nominal diameter, lipped (Model HV11), standard rubber, spring-
mounted (¾" [20 mm] travel), with #60 filter screen
Pads Shutoff:
Manual valve controls vacuum flow at outermost pads.
Pad Spread:
(to outer edges)
Minimum:
11" x 30" [279 mm x 762 mm] w/arms folded up
Maximum:
11" x 60" [279 mm x 1524 mm] w/arms folded down
Load Capacity:
(rated at 16" Hg [-54 kPa] on clean, smooth, nonporous flat surfaces
2
)
Per-Pad:
250 lbs [114 kg]
Maximum (w/2 pads): 500 lbs [228 kg]
Maximum (w/4 pads): 1000 lbs [455 kg]
Lifter Weight:
86 lbs [39 kg]
Vacuum Pump:
Diaphragm type, 3 SCFM [85 liters/minute] nominal airflow
Vacuum Reserve Tank: Vacuum reservoir helps prevent immediate vacuum loss in case of power failure.
Vacuum Gauge:
Dial gauge indicates current vacuum level in positive inches of Hg and negative
kPa.
Vacuum Lift Light:
Green light is energized whenever vacuum level is sufficient for lifting maximum
load weight (higher than 16" Hg [-54 kPa]).
Options:
See separate instructions about optional features.
Operating Elevation:
Maximum = 10,000 feet [3048 meters]
Operating Temperatures: 32° to 100° F [0° to 38° C]
Service Life:
This lifter is designed to have a service life of at least 20,000 lifting cycles, when
used and maintained as intended. Vacuum pads, filter elements and other wear-
out items are excluded; see MAINTENANCE and REPLACEMENT PARTS LIST for
more information. For the D
ISPOSAL OF THE
L
IFTER
after its service life, see
INTENDED USE.
ASME Standard BTH-1: Design Category "B", Service Class "0" (see www.powrgrip.com for more
information)
!!-CE-!! Note: This symbol appears in the
INSTRUCTIONS
manual only when requirements of a CE Standard are
different
from requirements of other standards that also apply to this vacuum lifter. CE requirements are mandatory
in geographical areas where CE Standards apply, but may be optional in other locations.
1
Options include oil-resistant rubber and pads with closed-cell foam rings for use on rough or textured surfaces.
2
Load Capacity is based on a friction coefficient of 1; see MAINTENANCE: V
ACUUM
P
AD
M
AINTENANCE
: Friction Coefficient for
additional information.