Pply the, Ads to a, Powering up the lifter – Wood’s Powr-Grip FL4HV11AC User Manual
Page 12

Rev 15.0/1-14
10
FL4HV11AC: #35030
CLOSED
PADS SHUTOFF VALVE
C
HARACTERISTICS
). Always use as many pads as possible for each load being lifted, in order to
maximize lifting capacity and minimize load overhang.
To lift loads less than 60" [152 cm] long, remove the cotterless hitch pin from one folding arm.
Fold the arm upward and insert the pin in the lower hole, to secure the arm in the upright
position. Push the pin through the arm until the retaining ball emerges on the far side. Repeat
this procedure for the second arm.
WARNING: Closing pads shutoff reduces lifting capacity to
500 lbs [225 kg].
Deactivate the outer vacuum pads by closing the pads shutoff: Place the
valve lever
perpendicular
to the vacuum line.
To lift loads greater than 60" [152 cm] long, reverse these
procedures: Secure the pad arms in the horizontal position, and
place the valve lever
parallel
with the vacuum line.
T
O
A
PPLY THE
P
ADS TO A
L
OAD
Powering up the Lifter
Make sure the lever on the vacuum control valve is in the center position (see T
O
R
ELEASE THE
P
ADS FROM THE
L
OAD
: About Stand-By Mode to follow). Place the power switch in the ON ( )
position, to engage the vacuum pump.
5
The lifter is designed for the vacuum pump to run
continuously.
WARNING: Never turn power off while operating lifter; keep pump running
throughout lift.
The power switch must remain in the ON position while operating the lifter. Placing the power
switch in the OFF ( ) position during lifter operation could result in the release of the load and
possible injury to the operator (see T
O
L
IFT AND
M
OVE THE
L
OAD
: In Case of Power Failure to
follow).
5
After the power switch is placed in the ON position, the vacuum lift light may subsequently turn on, because the lifter is
operating in stand-by mode at this stage. However, this does
not indicate that the lifter is ready to lift a load.