beautypg.com

Specifications – Wood’s Powr-Grip FL1HV11DC User Manual

Page 5

background image

Rev 3.0/9-13

3

FL1HV11DC: #35026

SPECIFICATIONS

Model Number:

FL1HV11DC

Description:

Designed for use with a crane or other hoisting equipment, the FL1HV11DC lifter
employs vacuum to hold a load for lifting in the flat orientation.

Power Source:

12 volts DC, 10 amps (with Thomas pump) or 3 amps (with Dynaflo pump)

Battery Capacity:

7 amp-hours

Vacuum Pad:

One 10" [25 cm] nominal diameter, lipped (Model HV11), standard rubber, with
#60 filter screen; Optional closed-cell foam ring for applications on rough or
textured surfaces.

Pad Spread:

11" x 11" [279 mm x 279 mm] to outer edges

Maximum Load Capacity:

300 lbs [135 kg], rated at 16" Hg [-54 kPa] on clean, smooth, nonporous flat
surfaces

1

Lifter Weight:

40 lbs [19 kg]

Vacuum Pump:

Diaphragm type, 1 SCFM [28 liters/minute] nominal airflow

Vacuum Reserve Tank:

Vacuum reservoir helps prevent immediate vacuum loss in case of power failure
and extends battery life by reducing pump cycles required to maintain vacuum.

Vacuum Gauge:

Dial gauge indicates current vacuum level in positive inches of Hg and negative
kPa.

Low Vacuum Warning Light: Red light is energized until vacuum level is sufficient to lift maximum load weight

(higher than 16" Hg [-54 kPa]) and whenever vacuum loss causes pump to re-
engage.

Low Vacuum Warning Buzzer: Maximum Alarm Volume = 103 dBA at 2 ft [60 cm]. While lifter is powered up,

audible alarm warns the operator whenever vacuum is not sufficient for lifting the

maximum load weight.

Options:

See separate instructions about optional features.

Operating Elevation:

Maximum = 6000 feet [1828 meters]

Operating Temperatures:

32° to 104° F [0° to 40° C]

Service Life:

This lifter is designed to have a life of at least 20,000 lifting cycles, when used and

maintained as intended. Vacuum pads, filter elements and other wear-out items
are excluded; see MAINTENANCE and REPLACEMENT PARTS LIST for more

information. For the D

ISPOSAL OF THE

L

IFTER

after its service life, see INTENDED

USE.

ASME Standard BTH-1:

Design Category "B", Service Class "0" (see www.powrgrip.com for more

information)

!!-CE-!! Note: This symbol appears in the

INSTRUCTIONS

manual only when requirements of a CE Standard are

different

from requirements of other standards that also apply to this vacuum lifter. CE requirements are mandatory

in geographical areas where CE Standards apply, but may be optional in other locations.

1

Load Capacity is based on a friction coefficient of 1; see MAINTENANCE: V

ACUUM

P

AD

M

AINTENANCE

: Friction Coefficient for

additional information.