beautypg.com

Assembly – Wood’s Powr-Grip PT10FS10TAIR User Manual

Page 8

background image

Rev 12.0/3-13

6

PT10FS10TAIR: #35143

ASSEMBLY

1) Open the shipping container and remove all materials for restraining or protecting the vacuum

lifter. Save the container for use whenever lifter is transported.

2) Connect the lifter to an appropriate compressed air supply (see SPECIFICATIONS: Power

Source), as follows:
Install the female quick connector (supplied) on the compressed air line. Connect the female

quick connector to the male quick connector leading directly to the air supply valve.
Adjust the air pressure regulator to supply an air pressure of 60 to 80 psi [415 to 550 kPa]:

Place the slide on the air supply valve in the “ON” position, to engage the compressed air
supply. Then pull up the adjustment collar on the top of the regulator, and turn the collar

clockwise to increase pressure or counter-clockwise to reduce pressure, as registered on the
pressure gauge. When the desired adjustment is obtained, push down the collar to lock it in
place.
Make certain the air line is routed so that it does not become tangled, kinked, pinched or cut

while operating the lifter or hoisting equipment (see step 4).
Note: Place the slide on the air supply valve in the “OFF” position when the lifter is not in

use; otherwise, the vacuum pump would continue to consume air, causing the air compressor
to cycle continually.

3) Suspend the lifter from a crane as follows: Select hoisting equipment (crane and hoist, when

applicable) rated to carry the maximum load weight plus the lifter weight (see
SPECIFICATIONS: Maximum Load Capacity and Lifter Weight).
Note: Any application of the lifter must conform to all statutory or regulatory standards that

relate to the hoisting equipment when used in its geographical location (eg, relevant OSHA
standards in the USA).
Raise the lift bar of the lifter to a vertical orientation: Engage the tilt actuator as though

tilting a load to the flat position (see OPERATION: T

O

T

ILT THE

L

OAD

); at the same time,

manually lift on the lift bar to assist the actuator’s movement. Then attach the hoisting
equipment hook to the lift shackle.

WARNING: Hoisting equipment hook must be fitted with restraining latch to

prevent lift shackle from slipping off under any circumstances.

Note: Some hoisting equipment hooks could interfere with an upright load that extends

beyond the lifter's pad frame. If the load would contact the hook during lifter operation, the
operator must prevent this by attaching a sling (or other rigging that does not interfere with
the load) between the hook and the lift shackle.

WARNING: Any sling used must be rated to carry maximum load weight plus

lifter weight.

Use the hoisting equipment to raise the lifter out of the shipping container. Be careful to

avoid damaging any vacuum pads. Remove the pad covers and save them for use whenever
the lifter is stored. Now the lifter is operational.

4) Perform Operational and Load Tests for the lifter as directed in MAINTENANCE: T

ESTING

S

CHEDULE

.