Waldmann PULSE PIR version IV - with MFT, Typ I - Manual (Page 23)

23
Operating Manual Light Control “PULSE PIR - Vers. IV with MFT” ENG
Function 2.7
Special function
The special function is not avail-
able.
The function cannot be changed.
Explanation of the functions (part 6)
Function 3.1 - 3.6
Follow-up time
Function to adjust the time after
which the light is to be switched off
if no presence is detected.
The default setting of the follow-up
time is 10 min.
6 different follow-up times from 5
to 30 min can be set.
The function can be changed on
lights with sensors XXX /R
Function 4.1 - 4.6
Presence range
Function to set the detection range
of the presence sensor.
The default setting for the range of
the presence sensor is 100%.
The function can not be changed.
Fig. 3
Key I
Logo
Light
bar
Key II
LED I
LED II
Note: The functions written in
blue are not available.