Waldmann PULSE PIR version IV - with MFT, Typ I - Manual (Page 21)

21
Operating Manual Light Control “PULSE PIR - Vers. IV with MFT” ENG
Explanation of the functions (part 4)
Function 2.1
Sensitivity high
Function to change the sensitivity
of the presence control.
The function is basically set to
„OFF”.
The function can not be changed.
Function 2.2
Switch-on automatic
Function to admit or to suppress
automatic switch-on with insuf-
ficient light or in case of presence
(semi-automatic).
The default setting of this function
is ”ON”, i.e., the light is automati-
cally switched on in case of pres-
ence or insufficient light.
The light has to be switched on
manually even in case presence
was detected if the switch-on
automatic is inactive.
The function can be changed on
lights with sensors XXX /R
Fig. 3
Key I
Logo
Light
bar
Key II
LED I
LED II
Function 2.3
Dual sensors
Function for the adjustment of the
operating mode when used with
an additional presence sensor
(optional accessories).
The default setting of this func-
tion is “OFF”, i.e., the switch-on
automatic works when a presence
is detected by one of the two
sensors.
Both sensors must detect a pres-
ence to turn on the light if this
function is active.
The function can be changed on
lights with sensors XXX /R
Note: The functions written in
blue are not available.