Vortex Optics SPARC RED DOT SCOPE - Manual (Page 7)

13 12
Spar a ar p c ®
RED DO T
S
hooTing wiTh The
SPArC
The key thing to remember when shooting with the SPARC red dot
is to keep both of your eyes open! This will allow you to take full
advantage of the SPARC’s ability to get on target very quickly.
Note: When using the optional magnifier for distance shooting, you
may find it easier to shoot with one eye closed due to the increased
magnification.
The SPARC has less than one inch of parallax inside of 50 yards
and is parallax free beyond 50. This means that eye placement is not
critical —if you can see the dot on your target, you’ll hit there.
m
AinTenAnCe
The SPARC red dot will require very little routine maintenance other
than periodically cleaning the exterior lenses. If desired, the exterior may
be cleaned by wiping with a soft, dry cloth.
When cleaning the lenses, be sure to use products that are specifically
designed for use on coated optical lenses such as the Vortex Lens Pen
and FogFree Cleaning Kits.
Cleaning
• Be sure to blow away any dust or grit on the lenses prior to wiping the
surfaces.
• Using your breath, or a very small amount of water or pure alcohol,
can help remove stubborn things like dried water spots.
All components are permanently lubricated, so no additional lubricant
should be applied.
Lubrication
Note: Do not attempt to disassemble any components of the red dot.
Use the included lens cover to protect the SPARC when not in use.
Storage
• Remove the battery before putting in storage for extended periods.
• Avoid storage in direct sunlight or in any very hot location.
• Storage and use in extreme cold will shorten battery life.
T
roubleShooTing
Please check the following before returningthe SPARC for service:
If the red dot does not illuminate:
• Is the battery dead? Replace.
• Is the battery installed correctly? Be sure the battery is oriented with
“
+ ” lettering facing the cover.
• Is the battery cover loose? Be sure cover is snug and contact points
are clean.
• Is the SPARC in night vision compatible mode? Press the NV mode
button to return to standard daytime mode.
Be sure all mount screws are tight. You should not be able to twist or
move the SPARC in any direction. Many times, problems thought to be
with the scope are actually mount problems.
Note: For any issues not listed above, please view our online
Troubleshooting Guide at http://www.vortexoptics.com/content/troubleshooting.
If the red dot is not accurate: