Spar a ar p c – Vortex Optics SPARC RED DOT SCOPE User Manual
Page 3

5
4
Spar
a
ar
p
c
®
RED DO T
r
ed
d
oT
A
djuSTmenTS
Use a coin to remove the battery compartment cover. Install one CR 2354
battery so the “
+
”
lettering faces
outward and replace the cover.
When replacing the cover, be sure
it is fully screwed down.
Battery Installation
Note: The typical life of the
CR 2354 battery depends on dot
intensity setting
.
Waterproof Yes
Fogproof
Nitrogen gas purging
Shockproof Yes
Eye Relief Unlimited
Dot Size
2
moa
Dot Color Red
Illumination
Variable 10-position intensity
Night vision compatible mode
Parallax
Parallax free past 50 yards
Magnification
1x
2x with included magnifier
Weight
5.2 ounces (without base)
Length
3
inches
Objective Diameter
22 mm
Ocular Diameter
22 mm
Included Accessories
2x Magnifier
Tall Riser
Short Riser
Riser Shim
(2) CR 2354 Batteries
Hex wrench
Windage
90 moa
Elevation
90 moa
Per Rotation
45 moa
Per Click
1 moa
Adjustment Specifications
Available Accessories
ARD filter
SPARC Specifications
To activate the illuminated dot press and release the Power button. While
in night vision compatible mode, the
illuminated dot will not be visible
unless a night vision device is being
used (see page 6).
To deactivate the illuminated dot,
press and hold the Power button for
five seconds.
Note: If you forget to turn the
SPARC off after use, it will automatically shut down in six hours.
Powering Up
Power Button
Battery Compartment
Red Dot Average Operating Time
Mode
of
Operation
Normal
Night
Vision
Maximum
Brightness
120
hours
4200
hours
Minimum
Brightness
3400
hours
4600
hours
1300
hour
average
operating
time