Vortex Optics RANGER 1000 RANGEFINDER WITH HCD - Manual (Page 3)

4 5
Mode Selection
Ranger is factory set to HCD mode, yard, and
medium brightness. For most users, these will
be the preferred settings.
To change modes, after the Ranger is powered
up activate the Mode Selection by pressing and
holding the Menu button for at least four seconds. This must
be done when the crosshair is not displayed on the screen.
Once the Mode Selection screen displays, release the button.
As you progress through Mode Selection, you may exit at
any time and save your
settings by pressing
and holding the Menu
button for at least four
seconds—the Ranger will
then return to power-up
condition.
4 5
Set and Save Mode Selections in 3 Steps
Step 1 — Choose between the HCD and LOS Modes
After activating the Mode
Selection, press the Measure
button to toggle between the
HCD and LOS displays. Press
the Menu button to save your
desired choice and move to the
Yards/Meters selection screen.
Step 2 — Choose between Yards and Meters Display
Press the Measure button
to toggle between the Yards
and Meters display. Press the
Menu button to save your
desired choice and move
to the Brightness selection
screen.
Mode Selection
Display
Use the Measure
button to toggle
through each
Mode Selection
option.
Use the Menu
button to activate
the Mode
Selection displays.
Choose Between HCD and LOS
Choose Between Yards and Meters