Vortex Optics VMX-3T MAGNIFIER - Manual (Page 4)

3X MAGNIFIER
VMX-3T TM
7 6
VMX-3T A
DJUSTMENTS
Dot-Centering
Screw (Elevation)
Dot-Centering
Screw (Windage)
The dot-centering screws can be used to help center the red dot
in the VMX-3T’s field of view. After the VMX-3T is mounted
in front of red dot scope, the dot may seem off-centered while
viewing through the VMX-3T. This will not affect the point-of-
impact. If desired, the centering screws can be used to move the
dot up/down or left/right until the dot is more centered. Do
not force screws once resistance is felt and the end-of-travel range has
been reached.
Center the red dot image
Note: Perfectly centering the red dot in the VMX-3T is not
required for accuracy. Once the primary red dot optic has
been sighted in using its own adjustments, the adjustments
done to the VMX-3T using the centering screws will not affect
the point-of-impact.
The VMX-3T is easy to use and does not require any special
sight-in—just zero-in the red dot as normal and add the VMX-
3T behind for additional 3x magnification.