Vigo VG3020C - Manual (Page 4)

1. Prepare the sink base cabinet
Farmhouse sinks require custom order sink base cabinets with a
front cutout to accommodate a 10" deep sink. Build structural
supports on the inside frame of the sink base cabinet. The
structural supports must support the weight of the sink and any
attachments such as garbage disposals. When the sink is placed
onto the cabinet support, make sure the top of the sink is evenly
flush against the bottom of the countertop. Allow clearance for
water supply line and drains or garbage disposal, as necessary.
2. Make template and cutout
Depending on the installation option, make proper cutout of the
countertop. Vigo recommends a 1/4" reveal on 3 sides when
installed undermount style. For a flush mount or above counter
installation, cut countertop along with outside of sink profile. Front
end of Vigo Farmhouse sinks are designed to be installed 3/4"
extended out beyond the front end of the countertop. Cut
countertop accordingly. No template is provided due to the custom
nature of each application and installation. The actual sink is used
as the template guide for each installation. After centering the sink
and allowing for faucets and backsplashes, use a pencil to outline
the sinks as your guide for the cutout, allowing for any reveal
before the actual cutting.
3. Set the sink
Set the sink on top of the cabinet or into the cabinet front cutout.
Apply sealant if necessary as a gasket between the sink and
cabinet.
4. Install the countertop
Carefully clean bottom of countertop and top flange of sink with
denatured alcohol. Apply bead of silicone adhesive (not supplied)
around the top edge of the sink. Place countertop onto the sink.
Remove excess sealant from the lip of any surfaces with a cleaner
recommended by manufacture of adhesive sealant.
4