Undercover Flex - Manual (Page 4)

PAGE 4
QUICK START INSTALL GUIDE
© 2013 UnderCover, Inc.
All rights reserved.
UnderCover, Inc.
P.O. Box 620
Rogersville, MO 65742
To open the cover: Lower the tailgate
and pull the cable. While pulling on the
cable lift the panel up and towards the
cab. Repeat this for the next panel.
The UnderCover Flex has been outfit-
ted with a very secure latching assembly
to allow the truck to be operated with the
cover in the fully open position. To open
to this position, turn the red handle to the
open position and raise the cover.
Secure the cover by attaching the
prop rods. Remove the prop rod from the
j-clip on the cover mounting rail. Attach to
the cover by pressing onto the ball stud. To
close simply reverse this process.
Warning! Be sure to always close the
truck tailgate before closing the last
panel on the Flex cover, this will
prevent damage to the rubber seal.
If this is as far as you would like to
open the cover, you can secure it in this
position. Release the strap from the
stowed position by squeezing the tabs.
Attach the buckle at the bulkhead, pull
the strap to take up the slack and secure
the cover.
1
2
3
4