Quick start install guide – Undercover Flex User Manual

Page 3

PAGE 3

For C

ust

omer S

vic

e or W

arr

ant

y Issues

, C

ontac

t UnderC

er D

ire

ctl

y (866) 900-8800 w

.under

verinfo

QUICK START INSTALL GUIDE

Fold Cover up to Attach

Attach Cover/Drain Tubes

Once in the fully open

position place a front

retainer clamp, flat washer,

lock washer and the star

knob on the front mount-

ing bolt underneath the

cover and hand tighten.

Be sure the front retainer

clamp is clamping to the

side rail correctly. Test the

cover again for proper

operation, adjust as

needed, then tighten the

star knobs.

Attach the drain tubes to

the fittings at the front of

the bed rail and position

the tubes to divert water

out of the truck bed. This

can be done by placing

the tube behind a bed

liner, through an existing

hole in the bed, or by

drilling a 5/8” hole in the

bulkhead.

Once the cover is

located correctly, fold

the cover up to the

open position. Pull

the release cables on

the rear two panels

and turn the red

handle to the open

position to fold up

completely. Take care

to fold it gently so the

position of the cover

is not disturbed.

Note: If you choose to place the tube behind your bedliner, be sure your

drain holes in the bed are not clogged.

Note: If you choose to drill a hole, be sure to clean up the metal shavings.