Undercover D-Ring Hinge Version - Manual (Page 2)

QUICK START INSTALL GUIDE
Hidden Hinge Version
Refer to Model Specific Guide for
Special Notes Regarding Your Model
PAGE 2 For C
ust
omer S
er
vic
e or W
arr
ant
y Issues
, C
ontac
t UnderC
ov
er D
ire
ctl
y (866) 900-8800 w
w
w
.under
co
verinfo
.c
om
3
Front Mounting Bracket
Install the front
bracket to the truck
bed rail near the
bulkhead. Refer to
the Model Specific
Guide for measure-
ments and special
notes.
Use 2 clamps per
bracket, install one
clamp in hole 1 or 2
and one clamp in
hole 4. If hole 4 is
obstructed by the
truck bed, use hole 3.
Do not over
tighten and distort
the brackets.
TOP VIEW PASSENGER SIDE
PASSENGER SIDE
GAP
REFER TO MODEL SPECIFIC GUIDE FOR MEASUREMENT
1 2
3
4
FRONT BRACKET
FRONT BRACKET
FRONT BULKHEAD
SPIRAL RING TAB
FRONT BULKHEAD
4
Install Cover
With some assistance
set the bed cover on
the truck bed. Position
the female hinge over
the spiral ring tabs.
Install the spiral rings
into the holes in the
spiral ring tabs.
NOTE: The rings are
simply a safety measure
to prevent the cover
from slipping off of the
tabs in the open posi-
tion. Once the hydraulic
struts are attached and
the cover is closed and
locked, it is not possible
to lift the front of the
cover off of the spiral
ring tabs.
Place the Mylar tabs on
the back of the cab, in
front of the spiral rings.
SPIRAL RING
SPIRAL RING TAB
FEMALE HINGE
UNDERCOVER TONNEAU
TOP VIEW