Traditions Vortek StrikerFire - Manual (Page 42)

Step: #2
Rifle Detailed Disassembly:
1. Remove Ram Rod from rifle (#55).
2. Remove forend stock screw (#40) and forend (#41) from barrel
assembly using the 4mm Allen wrench provided with your rifle.
(TIP-Use the forend to store parts so you will not lose them)
3. Remove Barrel (#50) from Receiver (#27).
4. Locate Safety Button (#10). Using your 4mm Allen wrench as a
punch slowly push Safety Button (#10) from left to right and remove
it from the Butt Stock (#1).
Only press this
side of safety
button to
disassemble!
CAUTION: Only disassemble the Safety Button from left side to
the right. Removing the Safety button from the other direction can
damage your Safety Button, Spring and/ or Butt Stock
5. Remove Butt Pad (#2) using two fingers to depress the buttons.
6. Remove Stock Bolt (#3) and Stock Bolt Washer (#4) with a 6mm T-
handle wrench. Carefully slide Butt Stock (#1) from Receiver (#27).
7. Remove Striker Retention Spring (#11) from Striker Retention Pin
(#32)
8. Completely remove Striker Retention Pin (#32) from receiver (#27)
using a small punch.
9. Depress the Barrel Catch lever (#25) to remove Striker Assembly.
Remove from rear of the Receiver (#27).
WARNING: DO NOT ATTEMPT TO DISASSEMBLE RECEIVER.
THIS INCLUDES ANY PINS HOLDING THE RECEIVER TOGETHER.
10. Detailed disassembly is now complete.
Step: #3
Rifle Cleaning & Lubrication:
1. Clean inside of striker channel located in Receiver (#27) with a 20ga
bore mop or soft nylon brush lightly sprayed with degreaser/cleaner.
2. Clean Striker Assembly with gun degreaser/cleaner.
3. Spray degreaser/cleaner on trigger and sear components on bottom
of Receiver (#27).
4. Clean inside of Receiver (#27) in from of Barrel Catch Lever (#25).
42