Thermalright XWB-1 User Manual
Thermalright Fans

1366 Backplate
Water Block
Hose Clamp
1366 Mounting Bracket
1366 Spring-loaded Screw
plated
Nickel
7
PF 3/8 Water Inlet and
Outlet
Hose Clamp
1366 Mounting Bracket
Water Block
Chill Factor Thermal
Paste
Spring-loaded Screw
1366 Backplate
7
1
1
2
2
1
4
1
Disclaimer:
Thermalright does not assume any liability, expressed or implied.
bility for damage that may occur during installation and use.
The installer/user of the XWB-01 product(s) assumes all responsi-
Caution:
please seek a professional computer technician in your local area.
are doubtful about your ability to install the XWB-01 correctly,
if the instructions are not followed! Proceed with CAUTION! If you
computer and/or computer parts. You may damage your computer
The use of this particular product(s) may void any warranty on your
***A 24-hour LEAK TEST of XWB-01 is recommended before installation!!!***
Warning:
on the computer.
no leakage occurs before turning
the water block system to ensure
After installation, it is crucial to run
Step 4: Water Hose Installation
tion complete.
pliers to close and lock the clamps. Installa-
outlet hose and hose clamp. Use a pair of
width) and hose clamp and then mount the
Mount the center inlet hose (with the proper
Step 3: Securing the Water Block
to secure water block in place.
socket and through the screws. Tighten screws
Place the 1366 backplate underneath the CPU
Step 2: Mounting Bracket Installation
mounting holes on the motherboard.
the mounting bracket and then through the CPU
screws to insert through the mounting holes on
and then select the appropriate spring-load
Place the mounting bracket on top pf water block
Step 1: Thermal Paste Application
and bottom of the water block.
Apply an even layer of thermal paste to the CPU
Water Block XWB-01 1366