Thermalright HR-09 TYPE 4 - Manual

Installation
Component
Exploded View
The Ultimate Cooling Solutions ! www.thermalright.com
HR-09 Type4 Heatsink
HR-09 TYPE4
Heatsink
Important! Before proceeding with installation, please check for the most up-to-date
instructions at www.thermalright.com
Push Pin
61x12x1 Thermal Pad
Step 1: Thermal Pad Application
Apply 61x12x1mm thermal pad directly to
bottom of heatsink base
Step 3: Removal of Stock Heatsink
Before installation of HR-09, remove stock
PWN heatsink.
Step 4: Heatsink Installation
Place HR-09 Type 4 heatsink directly onto the
PWN chips. Insert push pins through mother-
board mounting holes and press down to secure
in place. Installation completed.
Mounting mechanism Type A
Mounting mechanism
Type B
1
2
3
Parts Name Piece(s)
1 HR-09 TYPE4 Heatsink
2
Push Pin 3
61x12x1 Thermal Pad
1
1
2
5
4
Mounting mechanism Type A 4
2
Mounting mechanism Type B 5 2
Mounting mechanism
Type B
Mounting mechanism
Type A
Step 2: Mounting Mechanism Selection
Select the appropriate mounting mechanism
that aligns with the mounting holes on your
motherboard. Insert at each end of heatsink
and then insert push-pins through holes on the
mounting mechanism.