Belkin P73941 - Manual (Page 7)

Installation
5
Please refer to the section that corresponds to your
version of the Windows operating system (OS).
Installation Procedure for Windows 98 SE OS
This installation procedure will successfully install two
USB 1.1 host controllers and a single USB 2.0
enhanced host controller.
1. Ensure that your computer is powered down.
2. Locate an available PCI slot on your computer.
3. Insert the PCI Card into the slot. Apply enough
pressure to ensure that it is fully seated.
4. Insert the Belkin USB 2.0 driver installation CD into
your computer’s CD-ROM drive.
5. Turn on power and boot-up the computer.
6. The Windows OS will recognize the PCI Card as a
“NEC USB Open Host Controller” and the “Add
New Hardware Wizard” dialog box will open. Click
“Next”.
7. Select “Search for the best driver for your device”
and click “Next”.
8. Uncheck all the boxes and click “Next”.