Telematrix SP550 User Manual

Page 30

Programming Voice Mail
(Administrator)

To program the Spectrum PLUS

one touch “MESSAGE WAITING” speed dial

key, follow these programming instructions.

Programming Voice Mail Dialing

1. Press and hold the “STORE” key for 6-

seconds to activate Administrator mode.

2. Press the “STORE” key multiple times

until “VOICE MAIL NO.” is displayed on
the LCD screen.

3. Enter the voice mail number. The area

code is not required if AREA CODE is pro-
grammed into memory.

4. Press the “STORE” key to store the voice

mail number into the VOICE MAIL mem-
ory key.

5. Enter the “PIN NUMBER”, up to 8-digits.

The PIN characters will not be displayed.

6. Enter the “SECONDS OF WAIT?”, up to 99

seconds.

7. To exit the program mode, press “DISC”

or continue to the end of programming by
pressing the “STORE” key multiple times
until the display reads “All Setup OK”.

Test the program

After programming voice mail, test the program by

placing a voice mail into the voice mail messaging

system. Wait for the Voice Mail button to illuminate.

Then, press the key located on the base unit (when in

OFF HOOK position) and it will dial the pre-programmed

numbering sequence. The “SECONDS OF WAIT” may
need to be increased if the voice mail was not retrieved

Note: This feature must be turned on by your local

service provider.

VOICE MAIL NO.

12/01

12:00

555-1212

PIN NUMBER

12/01

12:00

- - - - - - - -

SECOND OF WAIT?

12/01

12:00