Telematrix SP550 User Manual

Page 14

Connecting the Handset Cord

A 10-foot modular coil handset cord is
provided. (Be sure that the wall/desk
elevation stand has not been attached).
To install the cord, simply plug the
short end of the handset cord into the
modular jack on the handset. The long
end of the handset cord plugs into the
jack labeled “Handset” located on the
bottom of the Spectrum PLUS

base

unit. Place the line cord into the hand-
set coil cord channel located directly
below the jack.

Installing the Keycaps

Twenty-two (22) preprinted named
feature keycaps are provided to identify
the speed dial key.

There are eleven (11) clear keycaps
already installed. To install preprinted
keys, remove the clear keycap by

simply pulling up. Replace with the
preprinted keycaps or place hand

written paper index sheets under a
clear keycap. Program each speed dial
key for the specific function of the key.

There are four (4) additional clear keycaps and two (2) index sheets provided as
spares. Use these for your own personal speed dial identities. Write the speed dial
name on the blank speed dial index cards and insert into the blank keycaps. Place
the keycap on the correct memory speed dial location. (see index sheets provided
in box).

Handset C ord

PLASTIC KEYTOP

PLASTIC TOP CABINET

CLEAR "SNAP-ON" KEY CAP

PLASTIC TOP CABINET

OR SILK SCREEN KEY CAP

The twenty-two preprinted keycap names are below:

Call Fwd On

Call Back

Paging

Skip Msg

Information

Call Fwd Off

Cancel Call Back

Ring Again

FF Msg

911

Transfer

Call Park Save

Msg Rew

Msg

Conf

Call Pick-up

Del Msg

Emergency

DND

Group Call Pick-up

Rpt Msg

Help Desk

NOTE: For speed dial programming instructions,

see the section on “Programming Procedure For

Spectrum PLUS

Speed Dial Features” in this

manual.