Bosch SGSX - Manual (Page 13)

English 11
Typical Flame Characteristics
The burner flame should be blue in color and stable with no
yellow tips, excessive noise or fluttering. It should burn
completely around the burner cap.
Foreign particles in the gas line may cause an orange
flame during initial use. This should disappear with use.
Check burner to make sure port holes are not obstructed. If
the ports are clogged, see “Before Calling for Service” on
page 17.
NOTE:
An audible “pop” may be heard when the burner is turned
off manually, or when cycling in the ExtraLow® zone
(SGSX models). The “popping” may be louder with LP gas
than with natural gas.
Getting the Most Out Of Your
Appliance
Cooking Suggestions (For Best Results)
• Use a lid to keep a more constant cooking
temperature.
• Use proper cookware. (See “Proper Cookware” on
page 13.)
• Center the pan over the burner before turning the
burner on.
• Refer to the “Surface Burner Cooking
Recommendations” chart on page 11 for suggested
settings.
ExtraLow® (XLO) Techniques
• Use a higher XLO setting if the pan is uncovered.
• Check the food occasionally to see if the control knob
should be turned to a lower or higher setting.
• It is normal to stir food occasionally. This is especially
important when simmering for several hours, such as
homemade sauce or beans.
• Simmer bubbles may not be seen when the flame has
cycled OFF.
• While the flame is ON, there may be bubbling. There
should be at least steam and a slight quivering of the
liquid’s surface.
• The quantity and type of food affects which setting to
use.
• When lowering the flame setting, adjust it in small
steps.
• If a setting is too low to hold a simmer, bring the food
back to a boil before resetting to a higher heat.
• If an oversized pan is used, the simmer action may
occur more in the center. For even cooking, stir the
food around the outer edges into the food in the center.
Surface Burner Cooking Recommendations
Figure 11: Checking Flame Characteristics
Yellow Flames:
Further adjustment is required.
Yellow Tips on Outer Cones:
Normal for LP Gas.
Soft Blue Flames:
Normal for Natural Gas.
If the flame is completely or mostly yellow, verify that the
regulator is set for the correct fuel. After adjustment,
retest.
Some yellow streaking is normal during the initial start-
up. Allow unit to operate 4-5 minutes and re-evaluate
before making adjustments.
Food Start Cooking
Continue Cooking –
Standard Burners
Continue Cooking –
ExtraLow® Burners
BREADS
French Toast,
Pancakes, Grilled
Sandwiches
Med. – preheat skillet. Med. Lo to Med. Use Standard Burner setting.
CEREALS
Cornmeal, Grits,
Oatmeal
Hl – cover, bring water to a
boil, add cereal. Med. Lo to Med. – finish
cooking according to
package directions. XLO – to hold, cover.