Sunnex HM2017-44EXT - Manual (Page 12)

Sunnex Solo Spot Service & Installation Manual 12
Recommended separation distances between
portable and mobile RF communications equipment and the SoloSpot
TM
The SoloSpot
TM
is intended for use in an electromagnetic environment in which radiated RF disturbances
are controlled. The customer or the user of the SoloSpot
TM
can help prevent electromagnetic interference
by maintaining a minimum distance between portable and mobile RF communications equipment
(transmitters) and the SoloSpot
TM
as recommended below, according to the maximum output power of the
communications equipment.
Separation distance according to frequency of transmitter
m
Rated maximum
output power of
transmitter
w
150 kHz to 80 MHz
outside ISM bands
d = 3,5 P
150 kHz to 80 MHz
in ISM bands
d = 12 P
80 MHz to 800
MHz
d = 1,2 P
800 MHz to 2,5
GHz
d = 2,3 P
0,01 0,35 1,2 0,35 0,35
0,1 1,1 3,8 1,1 1,1
1 3,5 12 3,5 3,5
10 11 38 11 11
100 35 120 35 35
For transmitters rated at a maximum output power not listed above, the recommended separation distance
d in metres (m) can be determined using the equation applicable to the frequency of the transmitter, where
P is the maximum output power rating of the transmitter in watts (W) according to the transmitter
manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 The ISM (industrial, scientific and medical) bands between 150 kHz and 80 MHz are 6,765 MHz
to 6,795 MHz; 13,553 MHz to 13,567 MHz; 26,957 MHz to 27,283 MHz; and 40,66 MHz to 40,70 MHz.
NOTE 3 An additional factor of 10/3 is used In calculating the recommended separation distance for
transmitters In the ISM frequency bands between 150 kHz and 80 MHz and In the frequency range 80 MHz
to 2,5 GHz to decrease the likelihood that mobile/portable communications equipment could cause
interference If it is inadvertently brought into patient areas.
NOTE 4 These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects and people.
REV. 1
JULY 2008