Summit SWC1875B - Manual (Page 9)

9
 Model SWC1875B
1. Remove the lower door shaft assembly 2 by unscrewing the two lock screws 1. Be careful to hold the
lower glass door firmly after removing the screws. And then gently pull down to remove the lower
glass door from the middle hinge and place it on a padded surface to avoid the risk of damage. (Fig. 1)
2. Remove the upper door shaft assembly 7 by unscrewing the two lock screws. Be careful to hold the
upper glass door firmly after removing the screws. And then gently pull down to remove the upper
glass door from the top hinge and place it on a padded surface to avoid the risk of damage. (Fig. 2)
3. Unscrew and remove the middle hinge 6 and the right top hinge 8. (Fig. 2 & 3)
4. Pop out the cover caps on the left side of cabinet and use them to
cover the screw holes on the right
hand side.
5. Screw the middle hinge 6 and the alternative left top hinge 9 included in the fittings,
on the left hand
side of cabinet. (Fig. 2 & 3)
6. Unscrew and transfer the lower hinge bracket 5 to the opposite side. At the same time remove the
stopper pin 4 to the opposite designated position of the lower hinge bracket. (Fig. 1)
7. Relocate the upper and lower door shaft assembly to the designated positions.
8. Set the upper glass door to the designated position and install the two lock screws to connect the
upper door shaft assembly 7 with the upper glass door and tighten them before the door is leveled.
(Fig. 2)
9. Set the lower glass door to the designated position and install the two lock screws 1 to connect the
lower door shaft assembly 2 with the lower glass door and tighten them before the door is leveled.
(Fig. 1)
10. Remove the handles from the left side of the doors and install them on the right side. (See page 10.)