beautypg.com

Summit SCR312L User Manual

Page 8

background image

 The temperature you are setting will increase by one degree each time you press the UP

button, and will decrease by one degree each time you press the DOWN button.

 The range of the temperature control is from 34°F to 43°F.
 To view the set temperature at any time, press the UP or DOWN button. The set temperature

will flash in the display window for 5 seconds. After 5 seconds, the temperature inside the unit
will reappear in blue in the display window.


NOTE:
 If the unit is unplugged, or power is lost or turned off, you must wait 3 to 5 minutes before

restarting the unit. If you attempt to restart before this time delay, the unit will not start.

 When you use the unit for the first time or restart the unit after it has been shut off for a long

time, there could be a few degrees variance between the temperature you select and the one
indicated on the LED readout. This is normal and is due to the length of the activation time.
There should not be a problem once the unit has been running for a few hours.










DOOR LOCK

Your unit is provided with a lock and key combination.

The keys are located inside the plastic bag that contains the Owner’s Manual. Insert the key into the lock
and turn it counterclockwise to unlock the door. To lock the door, do the reverse operation, making sure
the metal pin is engaged completely. Remove the key and put it in a secure place for safekeeping.


DEFROSTING
This appliance requires no manual defrosting. During the operation of the compressor, ice will build up on
the evaporator plate which is at the back of inner cabinet. During the compressor’s off-cycle, the ice will
melt, drip down, and collect in a tray above the compressor, where the compressor’s heat evaporates the
water. If you notice excessive ice build-up on the evaporator, try setting the temperature slightly higher.
Also, be sure that the door gasket is sealing well.

SHELVES
The unit has three full-sized and one half-sized removable, chrome-plated wire shelves. To take out a
shelf, first remove its contents, then raise the back of the shelf slightly and pull the shelf out.

8