Summit SCR312L - Manual (Page 7)

INSTALLING THE STAINLESS STEEL HANDLE
This beverage merchandiser includes a stainless steel handle that is not required to operate the unit. To
install the handle, follow the instructions below:
1. Remove the door gasket on the side you wish to install the
handle - you can see two designated holes for handle
installation. The gasket is easily displaced by hand, no tools
are necessary.
2. Install the handle tightly as shown with two screws, lock
washers and flat washers provided. (DO NOT over tighten as
this will cause damage to the handle and stainless steel door
frame).
3. Replace the door gasket to its original position.
Handle
Door Frame
Gasket
Screw
Lock Washer
Flat Washer
OPERATING YOUR APPLIANCE
It is recommended you install the appliance in a place where the ambient temperature is between 72º and
78ºF (23º-26ºC). If the ambient temperature is above or below the recommended temperatures, the
performance of the unit may be affected. For example, placing your unit in extremely cold or hot
conditions may cause interior temperatures to fluctuate. The range of 34º-43ºF (1º-6ºC) may not be
reached.
CONTROL PANEL
TEMP
LIGHT
To control the inner light turn on/off.
UP
Used to raise (warm) the set temperature by 1°F/°C.
DOWN
Used to lower (cool) the set temperature by 1°F/°C.
ºF/ºC Selector
Choose to display temperature setting in Fahrenheit or Celsius. To change the temperature from
Fahrenheit to Celsius or from Celsius to Fahrenheit, press the
button for at least 5 seconds.
Setting the Temperature Control
 You can set the temperature by pressing the UP and DOWN buttons. When you press the two
buttons for the first time, the LED readout will show the original temperature set previously. (The
temperature preset at the factory is 38°F, or 3°C.)
7