Summit SCR312L - Manual (Page 5)

LOCATION OF PARTS
Handle
Half Shelf (Total 1)
Door
Digital Control Panel
Levelling Legs Security Lock
Interior Light
Full Shelf (Total 3)
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
 Remove the exterior and interior packing.
 Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
 Clean the interior surface with lukewarm water using a soft cloth.
 Install the handle on the door. (See page 7.)
INSTALLATION OF YOUR APPLIANCE
 The appliance is designed for free-standing installation only.
 WARNING: Do not store or install the appliance outdoors.
 CAUTION
: This appliance is designed for storing and cooling beverages and drinks. Do not store
perishable food, medicine or other medical products.
 Place your Beverage Merchandiser on a floor that is strong enough to support it when it is fully loaded.
To level the unit, adjust the front leveling legs.
 For free-standing installation, leave 5 inches (127mm) of space around the back and sides of the unit
to allow proper air circulation to cool the compressor and condenser.
 NOTE: It is recommended that you do not install the appliance near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Don’t install in a location where the temperature will fall below 60°F (16°C). For best
performance, do not install the appliance behind a cabinet door or block the base grille.
 Avoid locating the unit in moist areas.
 Plug the Beverage Merchandiser into an exclusive, properly grounded wall outlet. Do not under any
5