Summit SBC490 - Manual (Page 9)

8
Empty the cabinet and lay down the beer dispenser sideways so the door hinge side is
at the top. Be careful not to cause dents or scratches on the cabinet. Placing a soft
cloth or cardboard underneath the cabinet is recommended.
Casters (for use as a freestanding beer cooler)
Install casters, and turn the nuts clockwise to tighten.
Once all four casters have been tightened evenly, stand the cabinet in an upright
position.
Note : Allow the beer dispenser to stand in an upright position for 8-10 hours before
turning on.
1. Slide gasket over wing nut on bottom of draft arm assembly beer tubes. Slide gasket
up beer tube to draft arm base.
Draft Arm Assembly
2. Push wing nut on beer tube of draft arm assembly through hole in top of cabinet until
the draft arm is resting on cabinet top.
3. Align holes in draft arm base with holes in gasket and pilot holes in cabinet, then
secure guard rail to cabinet top (see below).
1. Place guard rail on top of cabinet.
Guard Rail
2. Fit the legs of the guard rail into the prepared holes in the cabinet top.
3. Secure the guard rail to the cabinet with the eight small Phillips-head screws.