Belkin N600 DB - Manual (Page 25)

23
aDDITIOnal CaPabIlITIes
adding a Drive
You can share a USB hard drive or flash drive to your network via
your Router’s USB port. Once connected, you can share files and
music with other computers and devices within your network.
Plug your USB hard drive into the USB port on the back of your Router.
You can manually check the status of your shared drive
by visiting the USB Print and Storage Manager. If you
have difficulty sharing a drive on your network, please
see the “Troubleshooting” section of this manual.
A few USB hard disks require more power than the Router’s USB port
provides. In these cases, you may notice the drive failing to come on
or remaining on for a short time. If your disk has an optional power
supply, please use it while the disk is attached to your Router.
adding a Printer
You can add a printer to your network via your Router’s
USB port. Once connected, you can print from various
computers and wireless devices within your network.
Plug your printer’s USB cable into the USB port
located on the back of your Router.
You can manually check the status of your printer by visiting
the USB Print and Storage Manager, found under the Belkin
icon displayed in your system tray (Windows) or menu bar
(Mac). If you have difficulty sharing a printer on your network,
please see the “Troubleshooting” section of this manual.
note: Each computer that will use the printer must have
both the Belkin software and the printer’s driver installed.
If the print driver is not installed, you will be asked to install
it by the Belkin USB Print and Storage Manager.