Two circuit remote ballast – Sportsliter Solutions Two circuit remote ballast User Manual

Page 2

Due to our continued efforts to improve our products, specifications are subject to change without notice.

For more information visit our web site:

http://www.sportslighting.com/

SLS0036 SLS 2 Remote Ballast Instruction-A 1/14

Drawing Number: 268-1220-9901

Supply Wiring:
1. Connect the supply wires to the proper lugs on switch.
2. Connect ground wire (6) to the ground lug (7) (Fig.4)
3. Provide effective strain relief to prevent wire damage.
4. Comply with all national and local electrical codes.

Caution: Protect exposed wires with approved insulators.

Fixture Wiring into Enclosure:
1. Connect the male plug of wiring harness and the female harness plug

inside enclosure. (

Figure 4) Snap securely.

2. Enclosure shall be properly grounded.
3. Close door and engage the latches. A lock is optional.

These instructions are not intended to be a comprehensive guide to all

installation issues. The installer is responsible for safe, secure mounting

suitable for the application. Once the enclosure is installed, give these

instructions to the equipment owner.

TWO CIRCUIT REMOTE BALLAST

INSTALLATION AND SERVICING INSTRUCTIONS