Sportsliter Solutions ArenaLED - Manual

ARENA LED SERIES
INSTALLATION INSTRUCTIONS
SLS0040 Arend LED Series Instruction-A 1/14
GENERAL SAFETY WARNING!
Dangerous voltages exist within these fixtures and all precautions usually observed in
handling high voltage equipment should be observed when replacing lamps, installing or
otherwise servicing these fixtures.
WARNING!
Fixtures must be grounded and installed in accordance with the National Electrical Code
and all local codes. Failure to do so may increase the RISK OF PERSONAL INJURY,
PROPERTY DAMAGE, FIRE AND DEATH. Install and use so product does not
cause a hazard and use only in environments for which the product is specifically marked.
This product contains chemicals known to the State of California to cause cancer, birth
defects, and/or other reproductive harm. Thoroughly wash hands after installing, handling,
cleaning, or otherwise touching this product.
CAUTION!
• Follow ALL luminaire manufacturer’s recommendations, product markings, instructions,
restrictions and warnings
• All electrical work must be done by a qualified electrician.
• Turn off electric power to all affected circuits and allow to cool before servicing.
• A regularly scheduled maintenance program should be established to retain optimum
light output and reduce heat retention. Dusting with a soft, clean, dry cloth is normally
sufficient for the optical assembly. Any accumulation of dust or dirt
should be removed regularly.
• Carefully read these instructions before installing product. If you do not understand
these instructions, before starting any work, contact your Hubbell Lighting distributor or
[email protected] or (864) 678-1000.
• Give instructions to facility owner/manager for future reference.
NOTE:
Do not open this product unless instructed by steps included in these instructions or by
Hubbell Lighting technical support personnel. Fixture has been designed with easy to
install mounting brackets. The fixture is approximately 75lbs.
Use caution when lifting and aiming.
Tools required: rachet wrench with ¾” socket
Instructions: (See figures 1-9)
STEP 1.
Attach aming protractor to yoke with (2) 8 ⁄
32
screws
STEP 2.
Mount yoke to cast arm with 1 ⁄
2
-13 bolt
STEP 3.
Adjust horizontal aiming with the aid of the aiming protractor.
Tighten bolt to secure position. Torque bolt to 25ft-lbs max.
STEP 4.
Adjust vertical aiming angle with the aid of the angle finder on the
endcap, then tighten the bolts on each side of the yoke to secure
the position. Torque bolts to 25ft-lbs max.
Installation Instructions
FIG. 1
FIG. 2
YOKE
CAST
BRACKET
STAR
WASHER
AIMING
PROTRACTOR
FIG. 3
ANGLE
FINDER
FIG. 4