Bissell GARAGE PRO 18P0 - Manual (Page 10)

10
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
M
aintenance and care
Cleaning the dirt tank
1. Unplug the unit from electrical outlet.
2. Remove the dirt tank by pulling up on both
handles to unlatch.
3. Ensure the dirt tank has been emptied.
4. The dirt tank may be washed in warm
water. Make sure it is completely dry
before reassembling.
5. Reattach the dirt tank to the main unit by
aligning the top of the dirt tank to the upper
portion of the vacuum. Use one hand to hold
the tank and use the other hand to clip the
handles to hold the tank securely.
Cleaning the filters
the filter should be checked every 15-30 days
and washed as needed to maintain performance.
frequency of cleaning will be based on individual use.
Primary filter
1. Unplug the unit from electrical outlet.
2. Remove the dirt tank by pulling up on both
handles to unlatch.
3. The filter is located inside the top portion of
the vacuum. Pull either black tab towards
the middle of the unit and remove.
4. Shake filter over trash can to release any
loose debris.
5. Use a damp cloth to wipe the inside and
outside of the filter if desired. Air dry
thoroughly before replacing.
6. To replace, hold one edge of the filter,
collapse and snap in.
7. Reattach the dirt tank to the main unit by
aligning the top of the dirt tank to the upper
portion of the vacuum. Use one hand to hold
the tank and use the other hand to clip the
handles to hold the tank securely.
ug110-4053_18P0_608.indd 10 6/13/08 12:35:32 PM