Spaulding Lighting Laredo LLC - Manual (Page 2)

STEP-V LAMPING
* Replace reflector (F).
* Engage the lamp to socket (S).
* To ensure proper contact, loosen the lamp
one turn then retighten.
METAL HALIDE - PULSE START OR HIGH PRESSURE SODIUM
FLUORESCENT
* Replace cover (H) making sure not to pinch wires.
* Insert fixture lead wires (Q) thru grommet (R).
* Loosen screw (G) and remove wire cover (H).
* Use pipe sealant before engaging conduit
FOR THROUGH WIRING USING CONDUIT
* Make the wire connections.
fittings to prevent water leakage.
* Remove hole plugs (N) for the conduit entry.
FIG. 6
FIG. 7
B
J
(Fig. 2)
(Fig. 5)
(Fig. 7)
H
R
Q
BLK
WHT
GRN
* Make sure that the lamp size is mogul base and
type matches the ballast specifications.
* Replace reflector (F).
* Engage the lamps to socket (S).
* Make sure the lamp size is PL-T 4-Pin
and type matches the ballast specifications.
FIG. 8
FIG. 9
HIGH PRESSURE SODIUM
STEP-IV WIRING
INSTALLATION INSTRUCTIONS
LAREDO LLC LUMINAIRE
(Fig. 9 & 10)
(Fig. 11)
Hubbell Lighting, Inc. Doc. Number: 93015030
A subsidiary of Hubbell Incorporated Revision: *
701 Millennium Blvd • Greenville, SC 29607
Phone: (864) 678-1000
REMOVING FRONT DIRECTOR FOR IMPROVING
FORWARD THROW BEAM DISTRIBUTION
* Loosen (4) retaining screws (E)
and remove reflector (F).
* Unbend the two tabs to remove
the front director (Z).
FIG. 12
* Replace reflector and tighten retaining
screws (E).
(Fig. 4)
(Fig. 4)
(Fig. 12)
FIG. 10
METAL HALIDE
PULSE START
FIG. 11
FLUORESCENT
NOTE: Provided only with Metal Halide.
NOTE: Use only ED28 lamp size for Metal Halide.
CAULKING
F
S
F
F
Z
UNBEND
TABS
(Fig. 12)
PAGE 2 OF 8
PAGE 2 DE 8
PAGINA 2 DE 8