Schwank IEP-1520 - Manual (Page 15)

15
IM110526
RD: JUNE 2011
RL; 1A
BA
InfraSave IEP-1520 Manual
ALWAYS WEAR COTTON OR OTHER FABRIC GLOVES WHEN REPLACING HEAT LAMP.
DO NOT TOUCH THE LAMP SURFACE WITH YOUR BARE HANDS - OILS FROM YOUR
SKIN WILL CAUSE DAMAGE TO THE LAMP.
The heater requires some disassembly to access electrical connections when replacing lamp.
Use a container to securely store disassembled components and screws.
Step 1
Compress the width of the protective screen to retract the
wire tabs from under one edge of the heater body.
Rotate the lose edge of the screen up and away from
heater body.
Pull the screen away from heater remove from other edge
of heater body - place safety screen in secure storage.
Step 2
Remove end cover at both ends of heater.
Six (6) Phillips screws hold the end cover in place.
Remove the screws to secure storage.
Step 3
Slide out the face plate at each end
of heater to expose both ends of the
heat lamp.
10. HEAT LAMP REPLACEMENT
The Heat Lamp will operate for approximately 5000 hours under normal conditions.
WARNING
Heater service should only be performed by a qualified electrician. Failure
to comply can result in personal injury, death, fire and property damage.
Always unplug or disconnect the heater from the electrical power supply
prior to any cleaning, maintenance or service work.