S&S Cycle EZFI on 2008-09 Touring Models - Manual (Page 4)

4
8- Remove the wires located in Table 1 from the ECM connector.
NOTE: The position numbers are located on the back of the connector. To remove the wires, insert the supplied plastic push pin into the round hole
between terminal cavities as shown in Picture 6. Make sure not to remove adjacent terminals when performing this operation.
9- Insert the EZFI™ wires into the ECM connector. The appropriate locations of the wires are found in Table 2.
Picture 6
ECM Pin # EZFI Color Signal/Function
23 Red Rear Injector
28 Orange Front Injector
37 Violet Throttle Position Sensor
72 White Ignition Switch
Table 2
ECM Pin# Stock Wire Color Signal/Function
23 Green/Grey Rear Injector
28 White/Yellow Front Injector
37 Brown/Violet Throttle Position Sensor
72 White/Black Ignition Switch
Table 1