S&S Cycle Closed Loop Oxygen Sensor Kit for Delphi Style S&S Replacement Module - Manual (Page 7)

7
16- Insert the white wire with an orange stripe into position #8. Next insert the white wire with the blue stripe into position #23, as shown in
Picture 13, below.
17- Confirm the terminals are all in proper alignment and reinstall the clear plastic cover. Now you can tuck the Sealed Electrical Tap into the
36-position connector cover and close it, making sure to get all the clips back in place. Finally, reinstall a wire tie at the base of the 36-position
connector. See Picture 14, below.
18- Confirm that there are two 15-amp fuses in the blue tap-a-fuse on the red wire. Then insert it into the fuel pump fuse slot as shown in Picture
15, below left. Take care not to disconnect the fuses as you slide it back into the fuse holder. See Picture 16, below right.
Picture 13
Picture 14
Picture 15 Picture 16