S&S Cycle Closed Loop Oxygen Sensor Kit for Delphi Style S&S Replacement Module - Manual (Page 6)

6
13- Remove the socket plugs in terminal positions #8 and #23. See Picture 10, below.
14- Using a Sealed Electrical Tap from the supplied hardware kit, open the cover and position it over the wire coming out of pin #26 (black with
a white stripe). Then slide the black wire with a white stripe from the S&S® harness into the secondary connection position. See Picture 11,
below.
15- Use a pair of pliers to firmly press the metal connector into place over both wires. See Picture 12, below.
NOTE: You can put a small amount of pressure on the connector as you position the wires to make sure they are in the correct position. Once the connector
is pressed in, close the blue plastic cover and listen for a click to confirm it is seated.
Picture 10
Picture 11
Picture 12