S&S Cycle 50 State Air Cleaner Kit 106-4735 for Victory Freedom Engines - Manual

1
Installation Instructions for S&S 50 State Air Cleaner Kit 106-4735
for Victory® Freedom® Engines
Instruction 106-4736
11-10-08
Copyright © 2008
by S&S Cycle, Inc.
All rights reserved.
Printed in the U.S.A.
IMPORTANT NOTICE:
Statements in this instruction sheet preceded by the following words are of
special significance.
WARNING
Means there is the possibility of injury to yourself or others.
CAUTION
Means there is the possibility of damage to the part or motorcycle.
NOTE: Other information of particular importance has been placed in italic type.
S&S recommends you take special notice of these items.
SAFE INSTALLATION AND OPERATION RULES:
Before installing your new S&S part it is your responsibility to read and follow
the installation and maintenance procedures in these instructions and follow the
basic rules below for your personal safety.
Gasoline is extremely flammable and explosive under certain conditions
•
and toxic when breathed. Do not smoke. Perform installation in a well
ventilated area away from open flames or sparks.
If motorcycle has been running, wait until engine and exhaust pipes have
•
cooled down to avoid getting burned before performing any installation
steps.
Before performing any installation steps disconnect battery to eliminate
•
potential sparks and inadvertent engagement of starter while working on
electrical components.
Read instructions thoroughly and carefully so all procedures are completely
•
understood before performing any installation steps. Contact S&S with any
questions you may have if any steps are unclear or any abnormalities occur
during installation or operation of motorcycle with a S&S part on it.
Consult an appropriate authorized Victory service manual for correct
•
disassembly and reassembly procedures for any parts that need to be
removed to facilitate installation.
Use good judgment when performing installation and operating
•
motorcycle. Good judgment begins with a clear head. Don’t let alcohol,
drugs or fatigue impair your judgment. Start installation when you are
fresh.
Be sure all federal, state and local laws are obeyed with the installation.
•
For optimum performance and safety and to minimize potential damage to
•
carb or other components, use all mounting hardware that is provided and
follow all installation instructions.
Motorcycle exhaust fumes are toxic and poisonous and must not be
•
breathed. Run motorcycle in a well ventilated area where fumes can
dissipate.
DISCLAIMER:
S&S parts are designed for high performance, off road, racing applications and
are intended for the very experienced rider only. The installation of S&S parts may
void or adversely effect your factory warranty. In addition such installation and
use may violate certain federal, state, and local laws, rules and ordinances as well
as other laws when used on motor vehicles used on public highways, especially in
states where pollution laws may apply. Always check federal, state, and local laws
before modifying your motorcycle. It is the sole and exclusive responsibility of
the user to determine the suitability of the product for his or her use, and the user
shall assume all legal, personal injury risk and liability and all other obligations,
duties, and risks associated therewith.
The words Victory®, Victory Freedom®, and all Victory part numbers and model
designations are used for reference only.
VICTORY WARRANTY POLICY: The S&S Hot Setup Kit is intended for competition use only. Purchase and installation of an S&S Hot Setup Kit voids
portions of the Victory Standard Limited Warranty. Dealers must call Victory for prior authorization before initiating any warranty repair.
REGULATORY NOTIFICATION: This kit can legally be sold for and used on exhaust pollution controlled vehicles, including those in the state of CA. Failing
to install or modifying any components is considered tampering with emission-related parts and can lead to substantial regulatory penalties.
WARRANTY:
All S&S parts are guaranteed to the original purchaser to be free of
manufacturing defects in materials and workmanship for a period of twelve
(12) months from the date of purchase. Merchandise that fails to conform
to these conditions will be repaired or replaced at S&S’s option if the parts
are returned to us by the purchaser within the 12 month warranty period or
within 10 days thereafter.
In the event warranty service is required, the original purchaser must call or
write S&S immediately with the problem. Some problems can be rectified by
a telephone call and need no further course of action.
A part that is suspect of being defective must not be replaced by a Dealer
without prior authorization from S&S. If it is deemed necessary for S&S to
make an evaluation to determine whether the part was defective, a return
authorization number must be obtained from S&S. The parts must be
packaged properly so as to not cause further damage and be returned
prepaid to S&S with a copy of the original invoice of purchase and a detailed
letter outlining the nature of the problem, how the part was used and the
circumstances at the time of failure. If after an evaluation has been made by
S&S and the part was found to be defective, repair, replacement or refund will
be granted.
ADDITIONAL WARRANTY PROVISIONS:
(1) S&S shall have no obligation in the event an S&S part is modified by any
other person or organization.
(2) S&S shall have no obligation if an S&S part becomes defective in whole or in
part as a result of improper installation, improper maintenance, improper use,
abnormal operation, or any other misuse or mistreatment of the S&S part.
(3) S&S shall not be liable for any consequential or incidental damages
resulting from the failure of an S&S part, the breach of any warranties,the
failure to deliver, delay in delivery, delivery in non-conforming condition, or
for any other breach of contract or duty between S&S and a customer.
(4) These S&S parts are designed exclusively for use in Victory motorcycles.
S&S shall have no warranty or liability obligation if an S&S part is used in any
other application.
S&S ® Cycle, Inc
.
14025 Cty Hwy G PO Box 215
Viola, Wisconsin 54664
Phone: 608-627-1497 • Fax: 608-627-1488
Technical Service Phone: 608-627-TECH (8324)
Technical Service Email: [email protected]
Website: www.sscycle.com