S&S Cycle Teardrop Air Cleaner Kit for 2002-Up Honda VTX 1800 Motorcycles - Manual (Page 2)

2
INSTALLATION
1- Remove the stock air cleaner housing according to the Honda® factory service manual.
2- Remove the intake duct control hose from the intake duct control solenoid according to the Honda factory service manual. See Picture 1.
3- Install the rubber vacuum line cap over the intake duct control solenoid fitting.
4- Remove the intake air temp sensor from the air box as shown in Picture 2.
5- Install the intake air temp sensor into the aluminum back plate with the included 10-24 x 1/2" socket head cap screws as shown in
Picture 3 making sure to use Loctite® 243 on the threads. Torque to 35-40 in-lbs.
6- Install standoffs in the three locations shown in Picture 4 using three ¼-20 x 1/2 low socket head cap screws. Apply Loctite® 243 and torque to
40-45 in-lbs.
Picture 1
Picture 2 Picture 3
Picture 4
Remove hose, install rubber
vacuum line cap on intake
duct control solenoid fitting.
Long standoffs
Short standoffs