S&S Cycle Rocker Arm Rebuild Kit for 1966-1984 Big Twin Engines - Manual (Page 3)

2- Remove the old bushing by fitting it with a 9/16-18 tap and using an arbor press or using a bushing removal tool.
3- Install the bushings.
NOTE: Use assembly lube on bushings and rocker arm bore during the press procedure.
a. Install the 90-4308-S bushing on the roller end of the rocker arm. The recess end of the bushing should be aligned with rocker arm. See
Picture 5. (The recess at end is to allow oil to flow behind it and into the oil hole in the rocker arm). Use an arbor press or vice and install the
bushing so that the outside edge of the bushing is .005”-.015” recessed into the end of the rocker arm. A socket with a slightly smaller OD
than the bushing will work as a driver.
b. Install the 90-4014 bushing on the push rod end of the rocker arm. One end of the bushing has a lead-in chamfer. Align rocker arm and
bushing. See Picture 5. Use an arbor press or vice and install the bushing so that the outside edge of the bushing is .005”-.015” recessed
into the end of the rocker arm. A socket with a slightly smaller OD than the bushing will work as a driver.
Picture 3
Picture 4
Picture 5
90-4014 90-4308-S
90-4308-S
90-4014