5. detaching and attaching the buzzer unit, 5. detaching, Attaching the buzzer unit – RKI Instruments TAN-5000 Series User Manual
Page 11: Caution

3 Product Components
3-5. Detaching and attaching the buzzer unit
- 11 -
TAN-5000
3-5. Detaching and attaching the buzzer unit
Detach or attach the buzzer unit from the single-unit case or multi-unit case according to the following
procedure.
(1) Attaching procedure
• Open the front cover of the buzzer unit.
• Make sure that the power switch of the buzzer unit is OFF.
• Insert the buzzer unit along the rail into the single-unit case or multi-unit case.
• Push it in until an click is heard and you feel that it is locked in.
• Gently pull it to make sure that the buzzer unit does not come off.
• Close the front cover of the buzzer unit.
(2) Detaching procedure
• Open the front cover of the buzzer unit.
• Make sure that the power switch of the buzzer unit is OFF.
• While pressing the lock lever on the lower right of the buzzer unit, hold the front cover and pull it out
of the case.
• Close the front cover of the buzzer unit.
Front cover
Press the lock
lever upward.
CAUTION
Turn off the power of the buzzer unit before attaching or detaching it. Otherwise, a failure may be
caused.
CAUTION
This is a precision device. Be careful not to drop it when detaching it. Dropping the unit
compromises its original performance or causes malfunctions.