RKI Instruments 65-2516RK - Manual (Page 10)

6 • 65-2516RK Oxygen Transmitter
10. Connect the wires to the to the applicable controller transmitter terminal strip as
shown in Figure 3.
Figure 3: Wiring the Oxygen Transmitter to a Controller
11. If shielded cable is used, connect the cable’s drain wire to an available chassis (earth)
ground at the controller. RKI controllers typically have a ground stud that can be used
to ground the cable’s drain wire.
ZERO
SPAN
4/20
FB +
24V
POWER/SIG
OXY
W G
SENSOR
TP - TP
+
White Green
Not
Used OXYGEN
Not
Used
Controller Transmitter
Terminals,Typical
+ 24 VDC
4 - 20 mA In
(FB or S)
Cable Shield