Accessories – RKI Instruments GasWatch 1 User Manual
Page 17
GasWatch Instruction Manual (Two-Gas)
Accessories • 13
Accessories
Arm Strap
The GasWatch is supplied with a standard wrist strap. The arm strap is an optional
accessory. You can use the arm strap to wear the GasWatch on your upper arm.
To install the arm strap:
NOTE:
The wrist and arm straps are secured to the GasWatch by a bar. The bar is
attached to the back of the GasWatch by two tabs.
1.
Pull the wrist strap out of the strap loop at the bottom of the GasWatch.
2.
Loosen the two screws that secure the oxygen sensor retainer, then remove the sensor
retainer.
3.
Slide the retaining bar out, then remove the wrist strap.
4.
Place the arm strap in the same position as the wrist strap.
NOTE:
Make sure you position the arm strap so you can use the velcro section properly
once the arm strap is installed.
5.
Slide the retaining bar into its original position.
6.
Place the oxygen sensor retainer in its original position, then secure it to the GasWatch
with the two screws you loosened in step 2.
7.
Insert the opposite end of the arm strap through the strap loop at the bottom of the
GasWatch.