Retsch TG 200 - Manual (Page 23)

2/25/2013

Retsch GmbH
23
0002
Wearing parts
10 filter mats
Art. No. 72.143.0003
Vulkollan seal in quick clamping lid
Art. No. 05.111.0077
O-Ring on steel or glass vessel 185x4
Art. No. 05.114.0044
These operating instructions do not include instructions for
repairs. For your own safety repairs should be carried out only by
Retsch GmbH, an authorised agent or service technicians.
Fault codes
F1
PT100 temperature sensor is defective or not connected.
Connect or replace the temperature sensor.
F2
Overload temperature
Bimetal monitor on the heating tripped.
Reduce the set temperature at the TG200 by at least 5°C.
F3
Fault in blower
Blower has stopped or the speed is too low.
Increase the speed by at least 5 or replace blower.
Copyright
Passing on or duplication of this documentation, or use and
passing on of the contents, is allowed only with the express
permission of Retsch GmbH.
Persons infringing are liable to pay damages.
Alterations
Technical data subject to change without notice.