K7 k4, Operating the machine, 9 starting, interrupting, stopping – Retsch PT 200 User Manual
Page 22: 10 process run duration, 11 attaching vibratory feeder

Operating the machine
22
sample material.
Pos : 6.23 /00005 Ü berschriften/1.1 Ü bersc hriften/1.1 Übersc hriften BD A/11 Starten, U nterbr echen, Stoppen @ 0\mod_1229417133049_9.doc @ 5070 @ @ 1
5.9 Starting, Interrupting, Stopping
Pos : 6.24 /00010 Bedi enungsanleitung en Kapitels ammlungen/PT200 (2011)/0015 PT 200 Bedienung/1530 PT200 M odul Starten des Gerätes @ 3\mod_1301576388667_9.doc @ 24568 @ @ 1
Fig. 10: Starting the device
•
Press the START button (K7).
–
The green LED (K4) above the START button (K7) lights up.
–
The pre-set dividing time can be seen in the display.
–
The dividing tube starts to turn.
–
The remaining minutes of the division are shown in the display.
–
At the end of the dividing time the remaining seconds are shown.
Pos : 6.25 /00005 Ü berschriften/1.1 Ü bersc hriften/1.1 Übersc hriften BD A/11 Durc hlaufdauer @ 2\mod_1263289874150_9.doc @ 18528 @ @ 1
5.10 Process Run Duration
Pos : 6.26 /00010 Bedi enungsanleitung en Kapitels ammlungen/PT200 (2011)/0015 PT 200 Bedienung/1535 PT200 M odul Laufz eit ei nstellen @ 3\mod_1301576381823_9.doc @ 24478 @ @ 1
Fig. 11: Setting the throughput duration
•
Set the duration of the sample throughput by pressing the buttons
“time min.“.
You can choose the following time intervals:
(in minutes)
co (continuous) – 1 – 3 – 5 – 10 – 20 – 30 – 40 – 50 – 60
Pos : 6.27 /00005 Ü berschriften/1.1 Ü bersc hriften/1.1 Übersc hriften BD A/11 Zuteilger ät anbauen @ 3\mod_1302780202188_9.doc @ 25089 @ 2 @ 1
5.11 Attaching vibratory feeder
Pos : 6.28 /00010 Bedi enungsanleitung en Kapitels ammlungen/PT200 (2011)/0015 PT 200 Bedienung/1545 PT200 M odul Anbau des Z uteilg erätes @ 3\mod_1301576383277_9.doc @ 24496 @ @ 1
K7
K4