Purus Living 600 - Drop/Twist Grate - Manual (Page 3)

3
PURUSLINE LIVING WETROOM SOLUTION Wooden floor
02835
Important
Read all the pages of these instructions fully and thoroughly before
you commence installing and keep in a safe location for future
reference.
Always watch the installation DVD as an aid to installation prior to
installing. www.purusgroup.com
Plumbing
All plumbing work should be carried out by a fully qualified
professional plumber. 1½ inch ABS pipe adapter/connector
provided.
CHECK LIST/SAFETY NOTES
• If there is any movement or flexing whatsoever on the
joists or floorboards, then they need to be made good
and solid before installing. To make good, you must
add structural supports and/or braces to the joists and/
or floorboards. If there is still movement, do not fit the
product.
• Do not install the product on a raised platform. It is
designed only to be installed level with the surrounding
floor.
• Ensure you have all the contents supplied before installation. If you
do not have all the contents do not install. Contact your distributor
straight away.
• Check all the contents for damage. If any parts are damaged do not
install. Contact your distributor straight away.
• Check the level of the floorboards prior to installation. If they are
+or- 5mm this is acceptable. If they are over these tolerances do
not install.
• The grate when installed must be horizontal and flat. It also must
be level with the ceramic tile surface and not at an angle or on a
slope.
• Check where all pipes, electrical cables and all other services are
prior to drilling, cutting and screwing into walls, ceilings and floors.
• Use dry wall screws to fix the tray to the floorboards. When screwing
avoid any pipes, electrical cables and all other services.
• Ensure your tools for installation are fit for purpose and follow
manufacturer’s instructions provided with the tools.
• Do not use power tools on the screws of the Purusline Living
Wetroom Gully.
• The minimum height of tile is 10mm and the maximum height of
tile is 26mm including the tile adhesive.
• Remove any skirting boards in the room.
• Any gaps or holes/damage in the walls and floors must be made
good. We recommend appropriate tile backer boards or 18mm
marine plywood to level the room out.
• Do not put any primer on the tray. It is a good tip to prime your
walls/plasterboard before you install the tray with Puragum Primer
from the tanking kit.
• Always ensure the installation and working areas are kept safe,
especially from children and pets.
• Work safely; ensure that no tools are lying around and that the
working and installation areas are clean and tidy at all times.
• Ensure that all sharp devices such as knives and saws have covers
on them at all times. Do not carry knives in pockets.
• Safety goggles, masks and gloves should be worn at all times.
• The tanking kit covers 7-8m².
• Check the litres per minute output of your shower/showers before
choosing the waste outlet especially if you are going to use a pump.
The flow rate for the gully is 60 litres per minute for the Side and Side
Side waste outlets, and 30 litres per minute for the Low waste outlet.
Do not exceed these limits unless using multiple gullies.
Packaging
Once packaging has been unpacked and used it should always
be taken to the nearest local authority waste collection site for
recycling. The packaging must not be thrown away with normal
household waste.
Liability
The Manufacturer will not accept any liability for failure if the
Purusline Living Wetroom Solution has been installed incorrectly
and with disregard to the instructions.
It is extremely important when installing a wetroom that
you fully seal/tank the room.
Take your time. The tanking
of the room is the most important part. Check all tapes
and gaskets are secure and bonded before tiling. Ensure
that you test your room after tiling to ensure the room is
fully watertight. Do not use the wetroom/shower room until
tests are thoroughly completed.