Bissell FLIP-IT 5200 - Manual (Page 8)

8
With the Dry Side of the unit facing forward, turn
the unit on and begin cleaning.
You will see dry dirt, crumbs and debris being
collected in the Dirty Tank. You do not have to
empty the dry debris before wet cleaning.
To change from dry vacuuming, to wet cleaning
simply flip the unit around!
The Gentle Clean™ Brush or Pad and Squeegee
will automatically be lowered to effectively clean
and Dry all your Hard Floor Surfaces.
To begin Wet Cleaning, simply pull the Spray
Trigger. Water and Formula will be dispensed
through the Gentle Clean™ Brush or Pad.
To maximize the area to be cleaned, it is
recommended that the Spray Trigger is
squeezed on the forward stroke and released on
the rearward stroke.
This will dispense water and formula going
forward and on the pull back, the squeegee will
leave the floor essentially dry and ready to walk on.
Tip:
To extend the life of your
filter and to maintain
maximum dry suction,
check the filter for lint and
debris frequently
Wet Cleaning/Vacuuming
Flipping from Dry to Wet Cleaning
Tip:
To make sure water and
formula are flowing,
squeeze the Spray Trigger
without the Gentle Clean™
Brush or Pad Inserted. You
should see a light stream
of water and formula dis-
pensed unto the floor.
Dry Vacuuming
CAUTION:
Do not over wet the floor. Apply
solution by depressing the
trigger on the forward stroke
only and release the trigger
on the rearward stroke. Over
wetting the floor surface may
cause delamination of certain
laminated flooring materials.