Bissell FLIP-IT 5200 - Manual (Page 6)

6
Specialized Cleaning Features
Included with the purchase of your Flip It are the
following Specialized Cleaning Accessories…
The Flip-It was designed to give the user the
ability to easily change between the Gentle
Clean™ Brushes and Pads.
The Gentle Clean ™ Brush is recommended for
use on Hard Floor surfaces such as tile, vinyl,
slate or surfaces that have grout or crevices
where dirt and grime collect.
The Gentle Clean™ Pad is intended for use
on more delicate surfaces such as sealed
hardwood, laminates or vinyl.
The Pleated Filter, located in the lid of the Dirty
Tank should be cleaned periodically.
Assembling your new BISSELL Flip-It is a simple
2 Step Process:
NOTE: Remove clean tank from unit first.
Insert the Handle into the top of the unit, making
sure the Spray Trigger is on the Wet Vacuum side.
Make sure the screw opening in the handle is
aligned with the hole in the housing of the unit.
Insert screw; gently screw in until tight with the
body of the unit.
1.
2.
Putting It Together
3.
1.
2.
1.
2.
WARNING:
Do Not plug in your
cleaner until you have
completely assembled
it per the following
instructions and
operating procedures.
WARNING:
To reduce the risk of fire,
use only BISSELL Hard
and Wood Floor Cleaning
Solutions in your Flip-It.
Use of cleaning formulas
which contain lemon
or pine oil may damage
this appliance and void
the warranty. Chemical
spot cleaners or solvent
based soil removers
should not be used.
These products may
react with the plastic
materials used in your
Flip-It causing cracking
or pitting.